Rockwell Automation 5370 Color CVIM Communications Manual - Manual (Page 87)

Chapter 5
Using the RS–232 Ports
5–19
Use the Save command to transfer Color CVIM module configuration data to
the local storage area (EEPROM) or the external RAM card (credit card
memory).
Note: Depending upon the card size, up to 16 configurations can be saved to
the RAM card (512K card).
Use one of the following commands:
>S[CR] Transfers configuration data from the
Color CVIM module RAM to the EEPROM.
>S,CC,X [CR] Transfers configuration data from the
Color CVIM module RAM to the RAM card
area X (01 –16).
For example:
>S,CC,15 [CR] Transfers configuration data from the
Color CVIM module RAM to the RAM card
area 15.
You cannot use this command when the Color CVIM module is in the
SETUP mode.
After executing a command, the Color CVIM module will return: [CR][LF].
No data is returned. If you do not have the proper command structure, the
Color CVIM module will return: ?[CR][LF].
Save Configuration