Rockwell Automation 2755 2D Hand-Held Scanner User Manual
Page 131
Index
I–3
Publication 2755-6.4
I
IBM PC Wedge Cable
Advanced Features, 5–12
Country Selection, 5–10
Defaults, 5–9
Host Selection, 5–10
Intercharacter Delay, 5–11
Unknown Characters, 5–11
K
Keyboard Wedge Synapse Cable,
1–12, 2–8
Connecting, 2–9
L
Laser, Certification, A–2
Laser, Warning Label, 1–4
LEDs
Decode, 1–3
Green, 1–3
Location, 1–2
Red, 1–3
LRC Checksum, 4–10
M
Mechanical Specifications, A–2
N
No Read Message, 4–9
O
Operation, 3–1
Optical Specifications, A–1
P
Pause Duration, 4–12
PDF417 Bar Codes
2-Dimensional Codes, 1–2
Scanning, 1–7, 3–3
PLC Controller, Connecting to Scanner,
2–13
Power Supplies, 1–12
Prefix Data, 4–9
Protective Boot, 1–13
R
Raster Scanning
Aiming Dot, 1–5
Open Raster Pattern, 1–5
Slab Raster Pattern, 1–5
Smart Raster, 1–5
Read Ranges
1-Dimensional Codes, 1–8
2-Dimensional Bar Codes, 1–10
RS-232 Synapse Cable, 1–11, 2–6
Advanced Features, 5–8
Baud Rate, 5–3
Beep on BEL, 5–7
Check Parity, 5–4
Connecting to PLC, 2–13
Connecting to RS-232 Host, 2–7
Connecting to SLC, 2–14
Data Bits, 5–4
Defaults, 5–2
Hardware Handshaking, 5–5
Host Selection, 5–3
Parity, 5–4
Response Timeout, 5–7
RTS State, 5–5
Software Handshaking, 5–6
Stop Bits, 5–4
Unknown Characters, 5–7