Rockwell Automation LDC Iron Core Linear Servo Motors - Manual (Page 31)

Rockwell Automation Publication LDC-UM001B-EN-P - March 2011 31
Install the LDC-Series Linear Motor Chapter 3
8. Torque all screws to the values listed in the table, securing assemblies in
place by using all mounting holes.
SHCS
SHCS Torque
Black Oxide Steel
N•m (lb•ft) Stainless Steel
N•m (lb•ft)
M5 9.5 (7.0) 6.36 (4.7)
ATTENTION: Remove the alignment tool and make certain all the
magnet-track mounting hardware is flush or below the magnet
surface to prevent damage to the coil.