Cabletron Systems SFCS-200WG - Manual (Page 125)

B-7
SCP Diagnostics
B.1.2.7 Serial Port Test
This test checks the serial port’s functionality. It takes about two seconds to
run.
=> test-serial
Serial: OK
B.1.2.8 SRAM Test
This test checks the SRAM’s functionality. It takes about two seconds to run.
NOTE: It is recommended that you back up your
CDB before running this test. The SRAM is
saved before testing and then restored.
However, if a power failure would occur or if
the switch were rebooted during the test,
some of the data may not be restored
properly.
=> test-sram
SRAM: OK
B.1.2.9 Timer Test
This test checks to see if the timer is counting correctly. It takes about two sec-
onds to run.
=> test-timer
Timer: OK
B.1.2.10 Hardware Test
This series of tests checks the functionality of all of the hardware devices in
the SCP, except the FLASH chips and SRAM. It takes about fifteen seconds to
run.
=> test-all
Clock: OK
DRAM: OK
Ethernet: OK
Timer: OK
}Serial: OK