Cabletron Systems SFCS-200WG - Manual (Page 126)

B-8
SCP Diagnostics
B.1.2.11 Complete Hardware Test
This series of tests checks the functionality of all of the hardware devices, in
the SCP including the FLASH chips and SRAM. It takes about six minutes to
run.
NOTE: It is recommended that you back up your
CDB before running this test. The chips are
saved before testing each one and then
restored. However, if a power failure would
occur or if the switch were rebooted during
the test, some of the data may not be restored
properly.
=> test-manufact
Clock: OK
DRAM: OK
Ethernet: OK
Timer: OK
}Serial: OK
SRAM: OK
Flash Test
.
.
.
Erase Chip
Pattern 1
Erase Chip
Pattern 2
Erase Chip
Pattern 3
Flash: OK