Cabletron Systems SFCS-200WG - Manual (Page 147)

C-21
Hardware Specifications
C.3.2 ESA-200PC Technical Specifications
The ESA-200PC ATM Adapter provides ATM connectivity to EISA-based PCs
and servers, and has the following specifications:
Hardware
Architecture On-board 25 Mhz i960 RISC processor
AAL Support Special-purpose hardware for AAL5 and AAL3/4, HEC, and CRC
calculations
UNI 100 Mbps TAXI (4B/5B encoding);
155Mbps OC-3/SONET STS-3c/SDH STM-1
Form Factor Single-slot EISA bus, half-card
Compliance ATM cell processing per ANSI T1S1.5/92-002R3, ITU I.361, and
ATM Forum v3.0 UNI specification
Cabling Duplex 62.5/125
µ
m multimode fiber (2 km max. run, 10 dB loss);
2-pair 100 ohm CAT 5, or CAT 5 screened, UTP (100 meters max.)
Connectors ST and SC Types for multimode fiber; RJ-45 for CAT 5 UTP copper
Software
Transparent standard protocol interface NDIS 3.0, ODI Server
SPANS Switched Virtual Circuits (SVCs) signaling protocol
Permanent Virtual Circuits (PVCs)
Supports up to 1024 Virtual Circuit Identifiers (VCIs)
Support for UNI 3.0 signalling
Support for LAN Emulation Clients
General
Dimensions H: 0.6" x W: 5.0" x D: 9.4" (1.5 cm x 12.7 cm x 23.8 cm)
Weight 8.3 oz (235 g)
Power Requirements 2 amps (maximum) @ +5V
Operating Temperature 32˚F to 104˚F (0˚C to 40˚C)
Operating Humidity 20% to 80% non-condensing @ 40˚C
Compliance FCC Part 15, Class A Verification and UL 1950