Cabletron Systems SFCS-200WG - Manual (Page 149)

C-23
Hardware Specifications
C.3.4 PCA-200MAC Technical Specifications
The PCA-200MAC ATM Adapter provides ATM connectivity to PCI-based
Apple Power Macintoshes, and has the following specifications:
Hardware
Architecture On-board 25 Mhz i960 RISC processor
AAL Support Special-purpose hardware for AAL5 and AAL3/4, HEC, and CRC
calculations
UNI 100 Mbps TAXI (4B/5B encoding);
155Mbps OC-3/SONET STS-3c/SDH STM-1
Form Factor Single-slot PCI bus, half-card
Compliance ATM cell processing per ANSI T1S1.5/92-002R3, ITU I.361, and
ATM Forum UNI v3.0 specification
Cabling Duplex 62.5/125
µ
m multimode fiber (2 km max. run, 10 dB loss);
2-pair 100 ohm CAT 5, or CAT 5 screened, UTP (100 meters max.)
Connectors ST and SC Types for multimode fiber; RJ-45 for CAT 5 UTP copper
Software
Supports up to 1024 Virtual Circuit Identifiers (VCIs)
Support for UNI 3.0 signalling
Support for LAN Emulation Clients
General
Dimensions H: 0.5" x W: 3.3" x D: 5.8" (1.3 cm x 8.4 cm x 14.7 cm)
Weight 6 oz (170 g)
Power Requirements 2 amps (maximum) @ +5V
Operating Temperature 32˚F to 104˚F (0˚C to 40˚C)
Operating Humidity 20% to 80% non-condensing @ 40˚C
Compliance FCC Part 15, Class A Verification and UL 1950