Cabletron Systems SFCS-200WG - Manual (Page 23)

2-1
CHAPTER 2
Installing the 9A000
This chapter contains the procedures for installing the 9A000. The installation
of the SFCS series is covered in Chapter 3.
2.1 Installing the 9A000
To install the Cabletron 9A000, follow the steps below:
1. Switch off the power supplies and remove all power from the
MMAC-Plus chassis.
2. Remove the blank panels, covering the slots that the module is
being mounted in. All other slots must be covered, if modules are
not being installed, to ensure proper airflow and cooling.
3. Carefully remove the module from the shipping box. (Save the
box and packing materials in the event the module must be
reshipped.)
4. Attach one end of the ESD wrist strap packaged with the MMAC-
Plus chassis to your wrist. Plug the other end into the ESD Wrist
Strap Grounding receptacle in the lower right corner of the
MMAC-Plus Chassis shown in Figure 2.1.
5. Remove the module from the plastic bag. Observe all precautions
to prevent damage from Electrostatic Discharge (ESD).
6. Carefully examine the module, checking for damage. If any dam-
age exists, DO NOT install the module. Contact Cabletron
Systems Technical Support immediately.
7. The modules are installed into the chassis by sliding them into
slots and locking down both the top and bottom plastic tabs, as
shown in Figure 2.1. Take care that the module slides in straight
and engages the backplane connectors properly. When installing
the module, ensure that both circuit cards are between the card
guides, as shown in Figure 2.1. Check both the upper and lower
tracks of both cards.