Cabletron Systems SFCS-200WG - Manual (Page 57)

4-7
Switch Setup
4.5 Rack-Mounting an SFCS-200WG
The SFCS-200WG is designed to be installed either as a stand-alone unit
placed on the desktop, or as a rack-mounted unit using the optional rack-
mount kit (refer to section 4.2.1), which may be purchased separately. The fol-
lowing items should be addressed when rack-mounting this switch:
WARNING! When rack-mounting equipment, make sure
that a hazardous condition is not created due
to uneven weight distribution.
CAUTION Cabletron Systems recommends that the max-
imum operating temperature not exceed 40˚C.
Consideration must be made if the switch is to
be installed in a closed or multi-unit rack
assembly, because the ambient temperature of
the rack environment may be greater than the
room ambient temperature.
CAUTION Take care not to block the air vents of the
switch, as this would compromise the amount
of air flow required for proper cooling.
4.5.1 Required Tools
A set of rack-mount brackets, a cable relief strain rail, and 6 Phillips-head
screws can be purchased separately for rack-mounting the SFCS-200WG. You
will also need to supply a Phillips screwdriver.
WARNING! To prevent user injury and possible damage to
equipment, Cabletron Systems recommends
that at least two people be present when rack-
mounting the SFCS-200WG.