Cabletron Systems SFCS-200WG - Manual (Page 62)

4-12
Switch Setup
4.7 Installing the Serial Cable
Connect the serial cable (supplied with the switch) from the switch’s serial
port to any tty-type device (such as a terminal, or the serial port of a worksta-
tion or PC running a terminal emulation program).
NOTE: The switch’s tty port comes configured at
9600 baud, 8 bits, no parity and 1 stop bit.
When you turn on the switch, you should see the switch boot on the tty
device connected to the switch’s serial port.
NOTE: The switch is ready for user configuration asa
soon as it is connected to a tty-type device. To
access the switch, enter asx at the prompt of
the tty device.