Chapter 3 - network installation, Physical connection requirements, Hysical – Compatible Systems IntraPort A00-1869 User Manual
Page 21: Onnection, Equirements
Chapter 3 - Network Installation
15
Chapter 3 - Network Installation
This section of the manual describes how to connect the IntraPort Enterprise-8 VPN Access
Server to your Ethernet networks. In summary, the steps for installation are:
1.
After mounting the server or placing on a desktop, make sure it is not connected to
any power source.
2.
Connect the server to the Ethernet network(s).
3.
Connect a management console to the server (optional).
4.
Plug in the power cables and power up the server.
Figure 10. IntraPort Enterprise-8 VPN Access Server
Physical Connection Requirements
To connect each one of the IntraPort Enterprise-8’s Ethernet interfaces to twisted-pair Ethernet
cabling, you will need one unshielded twisted-pair station cable that is connected to a
10BaseT-compatible twisted-pair hub (for a transmit speed of 10 Mbps) or a 100Mbps Fast
Ethernet hub (for a transmit speed of 100 Mbps).
v Note: Ethernet cables and cable connectors are not supplied with the IntraPort Enter-
prise-8. Category 5 cabling is required for 100 BaseT operation. Please contact your reseller
or your Compatible Systems representative for information on obtaining the correct Ethernet
cabling supplies.