Chamberlain 248730 - Manual (Page 21)

20
Installation
STEP 10 Install the door control
To prevent possible SERIOUS INJURY or DEATH from electrocution:
•
Be sure power is NOT connected BEFORE installing door control.
• Connect ONLY to 24 VOLT low voltage wires.
To prevent possible SERIOUS INJURY or DEATH from a closing garage door:
•
Install door control within sight of garage door, out of reach of children at a minimum height of 5
feet (1.5 m), and away from ALL moving parts of door.
• NEVER permit children to operate or play with door control push buttons or remote control
transmitters.
• Activate door ONLY when it can be seen clearly, is properly adjusted, and there are no
obstructions to door travel.
• ALWAYS keep garage door in sight until completely closed. NEVER permit anyone to cross path
of closing garage door.
Install the door control within sight of the door at a minimum height of 5 feet (1.5 m) where small children
cannot reach, and away from the moving parts of the door. For gang box installations it is not necessary
to drill holes or install the drywall anchors. Use the existing holes in the gang box.
NOTE: Your product may look different than the illustrations.
HARDWARE
Screw
6ABx1-1/4" (2)
Drywall
Anchors (2)
Screw
6-32x1" (2)
Connect the door control wires:
1. Strip 7/16" (11 mm) of insulation from one end of bell wire and connect to the two screw
terminals on back of door control by color: white wire to WHT (1) and white/red wire to the RED
(2). If your garage is pre-wired for the door control, choose any two wires to connect, note
which wires are used so the correct wires are connected to the garage door opener in a later
step.
7/16" (11 mm) Top Mounting
Hole
Bottom Mounting
Hole
Top Mounting
Hole
Bottom Mounting
Hole
Install the Multi-Function Door Control:
1. Remove cover by gently prying at the top of the cover with a small flat head screwdriver.
2. Mark the location of the bottom-mounting hole and drill a 5/32 inch (4 mm) hole.
3. Install the bottom screw, allowing 1/8 inch (3 mm) to protrude from the wall.
4. Position the bottom hole of the door control over the screw and slide down into place.
5. Mark and drill the top hole.
6. Attach the top screw.
DRYWALL
GANG BOX
6-32x1"
6ABx1-1/4"
Drywall Anchor
OR
Install the Door Control Button:
1. Mark and drill 5/32 inch (4 mm) hole(s).
2. Fasten door control button to wall with screws.
DRYWALL
GANG BOX
6-32x1"
6ABx1-1/4"
Drywall Anchor