Coolant, Adding engine oil belo, Under the hood – BMW Z4 sDrive35i 2010 User Manual

Page 206

Advertising
background image

Under the hood

204

>

"Measurement inactive. Have this
checked."
Do not add engine oil. You can continue
your journey. Note the newly calculated dis-
tance remaining to the next oil service, refer
to page

69

. Have the system checked as

soon as possible.

Adding engine oil

Do not add 1 US quart/1 liter of engine oil until
a corresponding message is shown on the
Control Display.

Add oil within the next 125 miles/200 km;
otherwise, the engine damage could

occur.

<

Keep oils, greases, etc. out of the reach of
children and comply with the relevant

warnings on the containers. Otherwise, health
hazards may result.

<

Oil change

Have oil changed only at your BMW center or at
a workshop that works according to BMW
repair procedures with correspondingly trained
personnel.

Oil types

Do not use oil additives as these may
cause engine damage.

<

Specified engine oils

Your service center can advise you on which
engine oils have been approved by the manu-
facturer of your vehicle.
The engine oil quality is critical for the life of the
engine.

Approved oils can be identified by the following
specification:

Approved oils belong to the following viscosity
classes: SAE 0W-40, SAE 0W-30, SAE 5W-40
and SAE 5W-30.

Alternative oil types

If the approved engine oils are not available, up
to 1 US quart/1 liter of another oil with the fol-
lowing specification may be used:
API SM or higher

Coolant

Do not add coolant to the cooling system
when the engine is hot. Escaping coolant

can cause burns.

<

Coolant consists of half water and half additive.
Not all commercially available additives are suit-
able for your BMW. Ask your BMW center for
suitable additives.

Only use suitable additives; otherwise,
engine damage may result. Because

additives are harmful to your health, it is
important to follow the instructions on the con-
tainers.

<

Comply with the appropriate environ-
mental protection regulations when dis-

posing of coolant additives.

<

Checking coolant level

1.

Do not open the engine hood before the
engine has cooled down.

2.

Turn the expansion tank cap counterclock-
wise slightly to allow any accumulated pres-
sure to escape, then continue turning
to open.

Preferred:

BMW Longlife-01
BMW Longlife-01 FE

Alternative:

BMW Longlife-98

Online Edition for Part no. 01 41 2 602 883 - © 08/09 BMW AG

Advertising
This manual is related to the following products: