Tow-starting, towing away, Giving and receiving assistance – BMW 328i xDrive Sports Wagon 2009 User Manual

Page 234

Advertising
background image

Giving and receiving assistance

232

Preparation

1.

Check whether the battery of the other
vehicle has a voltage of 12 volts and
approximately the same capacitance in Ah.
This information can be found on the bat-
tery.

2.

Switch off the engine of the assisting vehi-
cle.

3.

Switch off any consumers in both vehicles.

There must not be any contact between
the bodies of the two vehicles, otherwise

there is a danger of shorting.

<

Connecting jumper cables

Connect the jumper cables in the correct
order, so that no sparks which could

cause injury occur.

<

Your BMW has a jump-starting connection in
the engine compartment which acts as the bat-
tery's positive terminal, refer also to the Engine
compartment overview on page

212

. The cap is

marked with +.

1.

Pull the cap of the BMW jump-starting con-
nection up to remove.

2.

Attach one terminal clamp of the plus/+
jumper cable to the positive terminal of the
battery or a starting-aid terminal of the vehi-
cle providing assistance.

3.

Attach the second terminal clamp of the
plus/+ jumper cable to the positive terminal
of the battery or a starting-aid terminal of
the vehicle to be started.

4.

Attach one terminal clamp of the minus/–
jumper cable to the negative terminal of the
battery or to an engine or body ground of
the assisting vehicle.

Your BMW has a special nut as body ground
or negative pole.

5.

Attach the second terminal clamp of the
minus/– jumper cable to the negative termi-
nal of the battery or to the engine or body
ground of the vehicle to be started.

Starting the engine

1.

Start the engine of the donor vehicle and
allow it to run for a few minutes at slightly
increased idle speed.

2.

Start the engine on the other vehicle in the
usual way.
If the first start attempt is not successful,
wait a few minutes before another attempt
in order to allow the discharged battery to
recharge.

3.

Let the engines run for a few minutes.

4.

Disconnect the jumper cables by reversing
the above connecting sequence.

If necessary, have the battery checked and
recharged.

Never use spray fluids to start the
engine.

<

Tow-starting, towing away

Observe the applicable laws and regula-
tions for tow-starting and towing vehi-

cles.

<

Do not transport any passengers other
than the driver in a vehicle that is being

towed.

<

ba8_E9091_cic.book Seite 232 Mittwoch, 29. Oktober 2008 2:59 14

Online Edition for Part no. 01 41 2 602 099 - © 10/08 BMW AG

Advertising