Axle self-leveling suspension – BMW X5 3.0i SAV 2006 User Manual

Page 96

Advertising
background image

96

n

2-axle self-leveling suspension

*

The concept

Your vehicle is equipped with 2-axle
self-leveling suspension acting on both
the front and rear suspension. This sys-
tem combines automatic self-leveling,
which compensates for variations in
front-to-rear load-distribution patterns,
with a selection feature allowing drivers
to choose from among several ride-
height options.

You may choose from among the fol-
lowing ride heights:
> Normal

The standard setting is intended for
most operating conditions, including
trailer towing

> Off-Road

Increased level for more ground
clearance

> Access

Lowers vehicle for more convenient
cargo handling or easier passenger
entries and exits.

Changes in ride height are initiated
either manually, using the control but-
ton, refer to page 97, or automatically in
response to specific speeds. When the
ride height is selected manually, the
driver has the additional option of revis-
ing the ride-height selection by entering

a new command during the adjustment
process.

When the vehicle is stationary, the sys-
tem executes ride-height changes in
both directions – up and down – when-
ever the doors are closed. The tailgate/
liftgate may be open. The system raises
the vehicle only when the engine is run-
ning.

The system's automatic self-leveling
feature automatically compensates for
variations in the vehicle's load.

The ground clearance of the vehicle
6.5-9 in/16.5-22 cm, depending on the
level selected.

Frequent changes in ride height
initiated at short intervals can

overheat the compressor, causing the
system to briefly suspend active opera-
tion.

<

Self-leveling suspension display

1 Off-Road

2 Standard

3 Access

The LEDs not only show the current ride
height, but also indicate changes:
> LED on: indicates the vehicle's cur-

rent ride height

> Ride-height LED flashes while the

LED for the earlier level remains on:
the ride height is being adjusted to a
new level, either automatically or in
response to driver input at the button.

When the suspension reaches the new
ride height the flashing LED reverts to
continuous operation, and the LED for
the earlier level goes out.

53

0d

e

2

18

Online Edition for Part No. 01 41 0 159 867 - © 07/05 BMW AG

Advertising
This manual is related to the following products: