Special operating instructions, Break-in procedures – BMW 330Ci Convertible 2005 User Manual

Page 124

Advertising
background image

124

Special operating instructions

Break-in procedures

To ensure that your vehicle continues to
provide maximum economy throughout
an extended service life, we request
that you devote careful attention to the
following instructions.

Engine and differential

The first 1,250 miles/2,000 km:

Drive at varying engine and road
speeds, but do not exceed an engine
speed of 4,500 rpm or a road speed of
100 mph / 160 km/h.

Always obey all official speed limits.

Do not use full throttle, and avoid
pressing the accelerator beyond the
kickdown point during these initial
miles.

You can then proceed to increase
engine or vehicle speeds once the ini-
tial 1,250 miles/2,000 km have elapsed.

Tires

Owing to technical factors associated
with their manufacture, tires do not
achieve their full traction potential until
an initial break-in period has elapsed.
We thus ask you to drive with extra care
during the first 200 miles/300 km.

Always obey all official speed limits.

Brake system

Approx. 300 miles/500 km must elapse
before the brake pads and rotors
achieve the optimal pad-surface and
wear patterns required for trouble-free
operation and an extended service life
later on.

To break in the separate parking brake
drums, apply the parking brake lightly
when coasting to a standstill, e.g. at a
traffic signal, provided that traffic condi-
tions permit to do so.

You can prevent corrosion in the drums
by periodically repeating this proce-
dure.

The brake lamps do not come on
when the parking brake is set.

Vacuum for the brake system servo unit
on your BMW is available only when the
engine is running. When you move the
vehicle with the engine off – when tow-
ing, for example – substantially higher
levels of pedal force will be required to
brake the vehicle.

<

Clutch

Approx. 300 miles/500 km must elapse
before the clutch starts to operate at
optimum efficiency. Remember to
engage the clutch carefully during this
initial period.

After replacing parts

Follow the same break-in procedures if
any of the components mentioned
above have to be replaced in the future.

Online Edition for Part-No. 01 41 0 158 118 - © 03/04 BMW AG

Advertising
This manual is related to the following products: