Driving, Ignition lock, Starting engine – BMW 645Ci Coupe 2005 User Manual

Page 55: Tion lock

Advertising
background image

Driving

54

Driving

Ignition lock

0 Steering locked

The key can only be inserted or removed in this
position.
After removing the key, turn the steering wheel
slightly until it locks.

Interlock on automatic transmission*

>

Only move the selector lever from
position P with the engine running.

>

To turn the key back to position 0 or to
remove it, first select the selector lever
position P.

1 Steering unlocked

A slight steering wheel movement often makes
it easier to turn the key from 0 to 1.
Some vehicle systems are ready for operation.

2 Ignition switched on

All vehicle systems are ready for operation.

3 Start engine

Starting engine

Do not run the engine in closed rooms, as
otherwise the inhaling of toxic exhaust

gases can cause unconsciousness and death.
The exhaust gases contain carbon monoxide,
an odorless and colorless, but highly toxic gas.
Never leave an unattended vehicle with the

engine running, as such a vehicle represents a
potential safety hazard.
To prevent the vehicle from rolling, always
select neutral position or position N and apply
the handbrake before leaving the vehicle with
the engine running.

<

When starting the engine, do not press the
accelerator pedal.
Do not allow the engine to warm up by leaving it
running while the vehicle remains stationary.
Instead, begin to drive immediately at a moder-
ate engine speed.

Special starting conditions

Press the accelerator pedal halfway down when
starting if

>

the engine fails to start on the first attempt,
for instance, if it is very hot or cold

>

the engine is started at very low tempera-
tures, below approx. +5

7/–156, at high

altitudes, above 3,300 ft/1,000 m

Avoid frequent starting in quick succes-
sion or repeated start attempts in which

the engine does not start. Otherwise, the fuel is
not burned or inadequately burned and there is
a danger of overheating and damaging the cat-
alytic converter.

<

Manual transmission

1.

Apply the handbrake.

2.

Gearshift lever in neutral position.

3.

Press the clutch pedal.

If the clutch pedal is not depressed,
the engine will not start.

<

4.

Start the engine.
Do not terminate the starting operation too
early, but after approx. 20 seconds at the
latest. When the engine starts, release the
ignition key immediately.

Online Edition for Part-No. 01 41 0 158 445 - © 09/04 BMW AG

Advertising
This manual is related to the following products: