BMW 745i Sedan 2005 - Manual (Page 203)

Mo
b
il
it
y
201
Refe
re
n
c
e
A
t a gl
anc
e
Cont
ro
ls
Dr
iv
in
g t
ip
s
Co
mm
uni
c
a
ti
o
n
s
Na
viga
ti
on
Ent
e
rt
a
inm
e
n
t
Replacing components
Onboard tool kit
The onboard tool kit is located in the lug-
gage compartment lid.
Loosen the wingnut to open.
The adapter for the spare key can be stored
beneath the open-ended spanners.
Windshield wiper blades
To replace the blades, start by folding the
wipers out and away from the windshield,
refer to page
73 .
Lamps and bulbs
The lamps and bulbs are essential factors
contributing to the safety of your vehicle.
Therefore, comply fully with the following
instructions during bulb replacement. If you
are not familiar with the specified proce-
dures, BMW recommends having the
replacements carried out at your BMW
center.
Never touch the glass of new bulbs
with your bare fingers, as even minute
amounts of contamination will burn into the
bulb's surface and reduce its service life.
Use a clean cloth, napkin, etc., or hold the
bulb by its metal socket.
<
You can obtain a selection of replacement
bulbs at your BMW center.
To prevent short circuits, before
working on any electrical system,
equipment or accessory you should always
switch it off and disconnect the cable from
the battery's negative terminal before start-
ing.
To avoid possible injury or equipment dam-
age when changing bulbs, observe any
instructions provided by the bulb manufac-
turer.
<
When maintaining the headlamps,
please comply with the instructions in
the separate Caring for your vehicle bro-
chure.
<
Headlamps
For checking and adjusting headlamp
aim, please contact your BMW cen-
ter. <
Engine compartment, left side:
Turn the quick-release snaps 90
5 counter-
clockwise and remove the cover.
After replacing the bulb return the cover to
its original position and press the quick-
release clamps down.
Online Edition for Part-No. 01 41 0 159 154 - © 09/04 BMW AG