FORD 2013 F-550 v.2 - Manual (Page 69)

Optional Settings
You can configure these settings while programming a MyKey or change
them while using an admin key:
• 80 mph (130 km/h) vehicle speed limit. Drivers receive visual
warnings and an audible tone when they reach 80 mph (130 km/h).
• 45, 55 or 65 mph (75, 90, or 105 km/h) vehicle speed warning. Drivers
receive visual warnings and an audible tone when they exceed the
preselected vehicle speed.
• 45% of the maximum audio system output. The audio system displays
a message when drivers attempt to exceed the volume limits.
• AdvanceTrac. Program the system to Always-on and these features,
if your vehicle is equipped, cannot be turned off when drivers use a
programmed MyKey.
CREATING A MYKEY
Use the information display to create a MyKey.
For Type 1 information displays:
1. Insert the key you want to program into the ignition. With a
push-button start (if equipped), put the Intelligent Access key in the
backup slot; see the Starting and Stopping the Engine chapter for
the backup slot location.
2. Turn the ignition on.
3. From the main menu within the information display, press SETUP
using the information display buttons until PRESS RESET TO
CREATE MYKEY displays.
4. Press and release the RESET button. The message HOLD RESET
TO CONFIRM MYKEY will display.
5. Press and hold the RESET button for two seconds until MARK
THIS AS RESTRICTED displays. Wait until KEY RESTRICTED
AT NEXT START displays, confirming that your key is successfully
programmed.
Make sure you label your key so you can distinguish it from the admin keys.
For Type 2 information display controls:
1. Insert the key you want to program into the ignition. With a
push-button start (if equipped), put the Intelligent Access key in the
backup slot; see the Starting and Stopping the Engine chapter for
the backup slot location.
2. Turn the ignition on.
68 MyKey
2013 F-250/350/450/550 (f23)
Owners Guide gf, 2nd Printing, December 2012
USA (fus)