FORD 2008 F-550 v.1 - Manual (Page 114)

Note: There are 30 seconds in which to initiate Step 7.
7. Return to the vehicle and firmly press, hold for two seconds and
release the programmed HomeLink
௡ button. Repeat the
press/hold/release sequence again, and, depending on the brand of the
garage door opener (or other rolling code equipped device), repeat this
sequence a third time to complete the programming.
HomeLink
௡ should now activate your rolling code equipped device. To
program additional HomeLink
௡ buttons begin with Step 2 in the
“Programming” section. For questions or comments, please contact
HomeLink
௡ at www.homelink.com or 1–800–355–3515.
Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink
௡ to accept the signal
from the hand-held transmitter.
After completing Steps 1 and 2
outlined in the “Programming”
section, replace Step 3 with the following:
Note: If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.
• Continue to press and hold the HomeLink௡ button (note Step 3 in the
“Programming” section) while you press and release — every two
seconds (“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink
௡. The indicator light will
flash slowly and then rapidly after HomeLink
௡ accepts the radio
frequency signal.
• Proceed with Step 4 in the “Programming” section.
2008 F-250/350/450/550 (f23)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
114