Programmable features, Key fob programmable features, Electronics – Dodge 2012 Challenger-SRT - User Guide User Manual

Page 68

Advertising
background image

PROGRAMMABLE FEATURES

Electronic Vehicle Information Center (EVIC) – If Equipped
• The EVIC can be used to program the following Personal Settings. Press and release the

MENU

button until Personal Settings displays, then press the UP

or

DOWN

buttons to scroll through the settings. Press the SELECT

button to change

the setting.

• Language

• Hill Start Assist (HSA)

• Unlock Doors Automatically on Exit

• Turn Headlights On with Remote Key Un-

lock

• Remote Key Unlock

• Delay Power Off to Accessories Until Exit

• Remote Start Comfort Sys.

• Turn-by-Turn Navigation

• Sound Horn with Remote Key Lock

• Display ECO Mode

• Flash Lights with Remote Key Lock

• Keyless Enter-N-Go

• Headlamps On with Wipers (Available with

Auto Headlamps Only)

• Enable/Disable The Rear Park Assist Sys-

tem

• Delay Turning Headlights Off

• Display Units of Measure In

Key Fob Programmable Features
• The following features may also be programmed by using the Key Fob transmitter or the

ignition switch and driver's door lock switch.

NOTE:
Pressing the LOCK button while you are inside the vehicle will activate the Vehicle Security
Alarm. Opening a door with the Vehicle Security Alarm activated will cause the alarm to
sound. Press the UNLOCK button to deactivate the Vehicle Security Alarm.

Unlock On First Press
• To unlock either the driver's side, or all doors, on the first press of the UNLOCK button:

• Press and hold the LOCK button for at least 4 seconds, but no longer than 10 seconds.

Then, press and hold the UNLOCK button while still holding the LOCK button.

• Release both buttons at the same time.

Auto Unlock Doors On Exit
• To have all of the vehicle doors unlock when any door is opened:

• Enter your vehicle and close all the doors, and fasten your seat belt.
• Cycle the ignition switch between the LOCK and ON position four times, ending in the

LOCK position (do not start the engine).

• Press the power door UNLOCK switch to unlock the doors. A single chime will indicate

that programming is complete.

ELECTRONICS

66

Advertising
This manual is related to the following products: