Accessory positions with engine off, Theft alarm, To arm – Dodge 2012 Charger_SRT - User Guide User Manual

Page 13: Getting started

Advertising
background image

• To stop the cranking of the engine prior to the engine starting, press the button

again.

NOTE:
• In case the ignition switch does not change with the push of a button, the RKE

transmitter (Key Fob) may have a low or dead battery. In this situation a back up
method can be used to operate the ignition switch. Put the nose side of the Key Fob
against the ENGINE START/STOP button and push to operate the ignition switch.

Stopping

• Place the shift lever in PARK.

• Press the ENGINE START/STOP button once. The ignition switch will return to the

OFF position.

If the shift lever is not in PARK, the ENGINE START/STOP button must be held for two

seconds and vehicle speed must be above 5 mph (8 km/h) before the engine will shut
off.

Accessory Positions with Engine Off

NOTE:
• The following functions are with the driver’s foot OFF the Brake Pedal (Transmission

in PARK or NEUTRAL Position).

Starting With The Ignition Switch In The OFF Position:

• Press the ENGINE START/STOP button once to change the ignition switch to the

ACC position.

• Press the ENGINE START/STOP button a second time to change the ignition

switch to the ON/RUN position.

• Press the ENGINE START/STOP button a third time to return the ignition switch to

the OFF position.

NOTE:
• If the ignition switch is left in the ACC or

ON/RUN (engine not running) position
and the transmission is in PARK, the
system will automatically time out after
30 minutes of inactivity and the ignition
will switch to the OFF position.

THEFT ALARM

To Arm

• Press the Keyless Enter-N-Go Start/Stop button until the Electronic Vehicle

Information Center (EVIC) indicates that the vehicle ignition is “OFF”. Press the
power door lock switch while the door is open, press the Key Fob LOCK button, or
with one of the Key Fobs located outside the vehicle and within 5 ft (1.5m) of the
driver's and passenger front door handles, press the Keyless Enter-N-Go LOCK
button located on the door handle.

OFF

RUN

ACC

Press

Press

Press

GETTING STARTED

11

Advertising
This manual is related to the following products: