Cabletron Systems 9E531-24 - Manual (Page 21)

2-1
Chapter 2
Installing the SmartSwitch 9000
Module
Unpacking the Module
1. Carefully remove the module from the shipping box. (Save the box and
packing materials in the event the module must be reshipped.)
2. Remove the module from the plastic bag. Observe all precautions to prevent
damage from Electrostatic Discharge (ESD).
3. Carefully examine the module, checking for damage. If any damage exists,
DO NOT install the module. Contact Cabletron Systems immediately.
User Accessible Components
Figure 2-1 shows the various components that are accessible to the user. These
consist of an eight-position DIP switch, replaceable PROMs and sockets for RAM.
These components will be used for future upgrades. Instructions for installing the
components will be supplied with the upgrade kit.
Only qualified personnel should perform installation procedures.