Installation instructions, Tools and equipment required, Mounting on a wall – Cisco Cisco Multiband Wall-Mount Antenna AIR-ANTM5560P-R User Manual
Page 10
10
Cisco Multiband Wall-Mount Antenna (AIR-ANTM5560P-R)
OL-6847-01
Installation Instructions
Installation Instructions
The following sections contain procedures for installing the antenna on a wall or pole. The following
parts are included with your antenna:
•
Molded antenna mount
•
Molded wall mount
•
Articulating arm
•
Four 8-32 nylon lock nuts
•
Two 1/4-in. lock washers
•
Two 1/4-in. flat washers
•
Two 1/4-20 x 1-1/4-in. machine screws
•
Two 1/4-20 hex nuts
For mounting on a wall:
•
Four wall anchors
•
Four 8-18 x 3/4-in. self-tapping Phillips screws
For mounting on a pole:
•
Two worm tie clamps
Tools and Equipment Required
To install the antenna, you will need the following tools and equipment:
•
Adjustable wrench
•
A Phillips screwdriver
•
A pencil
For mounting on a wall:
•
A portable hand or electric drill
•
A 3/16 in. (4.7 mm) drill bit
For mounting on a pole:
•
A small flat-blade screwdriver
Mounting on a Wall
This section provides instructions for mounting the antenna on a wall. (See
.)