Canon MF4370DN - Manual (Page 24)

22
4 Set Up Network Connection (MF4370dn Only)
The LCD display turned OFF:
The machine may enter the Sleep mode while you are performing setup. Press
[Energy Saver] to turn the display back ON and continue the setup.
1
Press [Menu].
2
Press [ ] or [ ] to select <11 SYSTEM
SETTINGS>, then press [ OK ].
1 1 S Y S T E M S E T T I N G S
M E N U
3
Press [ ] or [ ] to select <3 NETWORK
SETTINGS>, then press [ OK ].
3 N E T W O R K S E T T I N G S
S Y S T E M S E T T I N G S
4
Press [ ] or [ ] to select <4 VIEW IP
ADDRESS>, then press [ OK ].
4 V I E W I P A D D R E S S
T C P / I P S E T T I N G S
5
Press [ ] or [ ] to select <4 IPv4>, then
press [ OK ].
4 I P v 4
V I E W I P A D D R E S S
For instructions on the settings for IPv6, see “Network
Settings,” in the e-Manual.
●
6
Press [ ] or [ ] to select <1 IP ADDRESS>, <2
SUBNET MASK>, or <3 DEFAULT GATEWAY >,
then press [ OK ].
1 I P A D D R E S S
I P v 4
If the machine is communicating to the network properly,
the IP address, subnet mask and gateway address are
displayed.
If not, IP address, subnet mask and gateway address are
not displayed.
If the machine does not get the IP address in 30 seconds
after you connect the LAN cable, turn OFF the main power
switch once, and then turn it ON again and wait for
another 90 seconds. If the machine still does not get the IP
address, ask your network administrator.
It is recommended that you take a note of the IP address
you confirmed here, because you need it for using the
Remote UI.
7
Press [Stop/Reset] to return to the standby
mode.
If they are not displayed, that indicates that the machine is
not communicating to the network. Please check the
setting of the IP address.
This is the setting for the Static IP. If the machine obtains IP address automatically in “Automatic Setting”,
skip this setting.
In this setting, you enter the IP address, subnet mask, gateway address manually. [Menu]
→ <11 SYSTEM
SETTINGS> → <3 NETWORK SETTINGS> → <1 TCP/IP SETTINGS> → <1 IPv4 SETTINGS> → <1 IP ADDRESS
AUTO> → <OFF> → <2 IP ADDRESS> → Enter the IP address → <3 SUBNET MASK> → Enter the subnet mask →
<4 GATEWAY ADDRESS> → Enter the gateway address → Press [Stop/Reset] → Turn OFF the main power →
Restart the machine.
For more information on this setting, see “Network Settings,” in the e-Manual. Once you complete the
setting, please proceed to “Check IP Address Setting,” on p. 21.
Manual Setting