CompuSTAR 2000AS - Manual (Page 14)

© 2001 Firstech, Inc. Page 14
ADDITIONAL FEATURES ADDITIONAL FEATURES ADDITIONAL FEATURES ADDITIONAL FEATURES
The CompuStar 2000AS remote-pager has additional features and expansion
possibilities.
Second Car Mode
Second Car Mode Second Car Mode Second Car Mode
CompuStar 2000AS remote-pager can be programmed to operate a second vehicle.
Press Buttons (III+IV) simultaneously for a ½ second to enter second car mode. A
red–bordered indicator box labeled 2 nd located on the top left-hand corner of your
CompuGlo LCD will darken illustrating that your are in this mode.
If you are in second car mode, you can program your remote-pager to the second
vehicle by following the steps illustrated in the section below entitled “Adding an
Additional Remote-Pager.” In order to exit second car mode, press Buttons (III+IV)
simultaneously again. Please contact your local authorized CompuStar dealer for
more information.
Adding an Additional Remote
Adding an Additional Remote Adding an Additional Remote Adding an Additional Remote----Pager Pager Pager Pager
Your remote-pager has been programmed at the factory. However, if you replace or
add an additional remote-pager, please perform the following:
Steps 1: Put the system in Valet mode with the key by turning the ignition on and off
five times with the mechanical car key within 10 seconds
. The parking light will flash
once.
Step 2: Within 6 seconds, press Button I for a ½ second.
Step 3: The parking light will flash twice to confirm Step 2.
Step 4: Program the second transmitter or third transmitter by pressing any button.
The system will program up to 3 transmitters. The parking light will flash once to
confirm Step 3.