Jeep 2009 Patriot - Owner Manual - Manual (Page 140)

Programming HomeLink
ா
Before You Begin
If you have not trained any of the HomeLink
௡ buttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for
20 seconds until the red indicator flashes.
It is recommended that a new battery be placed in the
hand-held transmitter of the device being programmed
to HomeLink
௡ for more efficient training and accurate
transmission of the radio-frequency signal.
Your vehicle should be parked outside of the garage
when programming.
1. Turn the ignition switch to the ON/RUN position.
2. Hold the battery side of the hand-held transmitter
away from the HomeLink
௡ button you wish to program.
Place the hand-held transmitter 1–3 in (3-8 cm) away
from the HomeLink
௡ button you wish to program while
keeping the indicator light in view.
3. Simultaneously press and hold both the chosen
HomeLink
௡ button and the hand-held transmitter button
until the HomeLink ௡ indicator changes from a slow to a
rapidly blinking light, then release both the HomeLink ௡
and hand-held transmitter buttons.
Watch for the HomeLink
௡ indicator to change flash rates.
When it changes, it is programmed. It may take up to
30 seconds, or longer in rare cases. The garage door may
open and close while you train.
NOTE:
• Some gate operators and garage door openers may
require you to replace Step 3 with procedures noted in
the “Gate Operator/Canadian Programming” section.
138 UNDERSTANDING THE FEATURES OF YOUR VEHICLE