Jeep 2010 Commander - Owner Manual - Manual (Page 210)

This feature allows you to plug an iPod
௡ into the
vehicle’s sound system through a 16–pin connector, using
the provided interface cable.
UCI supports Mini, 4G, Photo, Nano, 5G iPod
௡ and
iPhone ௡ devices. Some iPod௡ software versions may not
fully support the UCI features. Please visit Apple’s
website for software updates.
NOTE:
• If the radio has a USB port, connecting an iPod௡ to this
port does not play the media. For playing an iPod ௡,
use the separate 16–pin connector port (in the glove
compartment on some vehicles).
• Connecting an iPod௡ to the AUX port located in the
radio faceplate, plays media, but does not use the UCI
feature to control the connected device.
Connecting The iPod
ா
Use the provided connection cable to connect an iPod ௡ to
the vehicle’s 16–pin connector port (which is located in
the glove compartment on some vehicles). Once the
iPod
௡ is connected and synchronized to the vehicle’s UCI
system (iPod
௡ may take a few seconds to connect), the
iPod ௡ starts charging and is ready for use by pressing
radio switches, as described below.
NOTE:
• You may have to remove the connector pin protection
cap from the 16–pin connector port, prior to connect-
ing the cable.
• If the iPod௡ battery is completely discharged, it may
not communicate with the UCI system until a mini-
mum charge is attained. Leaving the iPod
௡ connected
to the UCI system may charge it to the required level.
210 UNDERSTANDING YOUR INSTRUMENT PANEL