Jeep 2012 Wrangler Unlimited - Owner Manual - Manual (Page 348)

Connecting The iPod
ா Or External USB Device
Use the connection cable to connect an iPod ௡ or external
USB device to the vehicle’s USB/AUX connector port
which is located in the center console.
Once the audio device is connected and synchronized to
the vehicle’s iPod
௡/USB/MP3 control system (iPod௡ or
external USB device may take a few minutes to connect),
the audio device starts charging and is ready for use by
pressing radio switches, as described below.
NOTE: If the audio device battery is completely dis-
charged, it may not communicate with the iPod ௡/USB/
MP3 control system until a minimum charge is attained.
Leaving the audio device connected to the iPod
௡/USB/
MP3 control system may charge it to the required level.
Using This Feature
By using iPod cable or external USB device to connect to
USB port:
• The audio device can be played on the vehicle’s sound
system, providing metadata (artist, track title, album,
etc.) information on the radio display.
• The audio device can be controlled using the radio
buttons to Play, Browse, and List the iPod ௡ contents.
• The audio device battery charges when plugged into
the USB/AUX connector (if supported by the specific
audio device)
Center Console USB/AUX Connector Port
346 UNDERSTANDING YOUR INSTRUMENT PANEL