Losi LOSB0289 Drift R Manual - Manual (Page 20)

32
92
151
93
61
91
62
91
31
27
B A G E
17
Figure 38
Figure 39
!
Step 1. Install a rear inner pivot block (91) by threading two 4-40
x 3/8" flat head screws (31) through the bottom of the chassis (27)
into the pivot block (91) as indicated in Figure 38. Repeat for the right
rear inner pivot block (91). The inner blocks are interchangeble from
left to right.
Figure 38
Figure 39
31
!
Step 2. Slide an inner hinge pin (62) through each of the two rear
arms (92) farthest away from the shock mounting hole.
Before you tighten the main block it may be necessary to slightly
loosen the screws in the inner pivots about 1 full turn. Once this is
done, tighten the main block, followed by tightening the inner
pivots. This will ensure you get the correct pin angle in the arms
!
Step 3. Position the arm (92) so that the shock mount hole faces
the back of the chassis (27). Slide a .060" spacer (61) over each side of
inner pins as indicated in Figure 39. Insert the arms (92) into the inner
rear pivot block (91). Capture the rear arms (92) by placing the rear
main block (93) onto the inner hinge pins (62) as shown in the
illustration in Figure 39A. Secure the rear main block (93) by
threading two 4-40 x 1/2" flat head screws (31) through the main
block (93) into the upper holes in the rear diff cover (32).
61 62
ASSEMBLE MAIN BLOCK
IN THIS DIRECTION
Figure 39A
151