Local management, 1 overview, Chapter 5 – Cabletron Systems 2H23-50R User Manual
Page 51: Overview -1, Refer to, For information on how to, Er to, Chapter 5 local management
2H23-50R/2H33-37R User’s Guide
5-1
CHAPTER 5
LOCAL MANAGEMENT
This chapter explains how to set up a management terminal to access
Local Management. It also explains how to use the Local Management
screens and commands.
5.1
OVERVIEW
Local Management consists of a series of screens that allow the
management of the 2H23-50R or 2H33-37R. The screens allow the user
to do the following tasks:
•
Assign IP address and subnet mask.
•
Select a default gateway.
•
Control access by establishing community names.
•
Download a new operation firmware image.
•
Designate which Network Management Workstations receive SNMP
traps from the device.
•
View bridge and port statistics.
•
Configure switch operations (802.1D, 802.1Q, or SecureFast
Switching).
•
Control the number of receive broadcasts that are switched out to the
other interfaces.
•
Clear NVRAM.
There are three ways to access Local Management:
•
Locally using a VT type terminal connected to the COM port of the
2H23-50R or 2H33-37R.
•
Remotely using a VT type terminal connected through a modem.
•
In-band through a Telnet connection.