Crestron electronic TPS-17B/W - Manual (Page 27)

Crestron Isys ® TPS-12B/W, TPS-15B/W & TPS-17B/W Tilt Touchpanels
INTERFACE MENU
Two buttons adjacent to the hexadecimal display, DOWN and UP, decrease and
increase the Net ID by one, respectively.
The four buttons at the bottom define how the RS-232 port can be used; as a console
port (i.e. loading touchpanel projects and firmware), a touch output port
(communication of touch coordinates to an external device), a mouse input port
(allows a mouse to control the touchpanel) and an external touch input (allows
another device to control the touchpanel).
The Ethernet Enable and Disable buttons determine the status of the touchpanel’s
Ethernet communications.
NOTE: The TPS-12B/W, TPS-15B/W & TPS-17B/W do not support a wireless
Ethernet connection.
There may be Ethernet devices (i.e. a control system) on the network that
communicates with the touchpanel via CIP (Cresnet Internet Protocol). Two buttons
located on the INTERFACE MENU determine if the touchpanel is capable of this
type of communication. Select Enable to permit this protocol recognition and
Disable to prohibit any CIP connection. CIP must be enabled for the touchpanel to
communicate with other Crestron Ethernet devices.
Select the Save and Return button located on the INTERFACE MENU to save
changes and return to the SETUP MENU.
Ethernet Setup Menu
Selection of the Ethernet button from the SETUP MENU displays the ETHERNET
SETUP MENU. This menu provides buttons for Ethernet Status Test (for details
such as the IP Address, Subnet Mask, Default Router, IP Table, etc.), DHCP
Enable/Disable and Static IP Options. Each of the Static IP Options has its own
menu, as shown in the illustrations on the following pages. The enable/disable
Ethernet feature is provided on the INTERFACE MENU. Ethernet settings are made
Operations Guide – DOC. 6464A Tilt Touchpanels: TPS-12B/W, TPS-15B/W & TPS-17B/W • 23