Operation, Using your garage door opener, Save these instructions – Chamberlain 3130M 1/3 HP User Manual

Page 26

Advertising
background image

26

OPERATION

Using Your Garage Door Opener

Your Security✚

®

opener and hand-held remote control

have been factory-set to a matching code which changes
with each use, randomly accessing over 100 billion
new codes. Your opener will operate with up to eight
Security✚

®

remote controls and one Security✚

®

Keyless

Entry System. If you purchase a new remote, or if you
wish to deactivate any remote, follow the instructions in
the Programming section.
Activate your opener with any of the following:
The hand-held Remote Control: Hold the large push

button down until the door starts to move.

The wall-mounted Door Control: Hold the push button

or bar down until the door starts to move.

The Keyless Entry (See Accessories): If provided with

your garage door opener, it must be programmed
before use. See Programming.

When the opener is activated (with the safety reversing
sensor correctly installed and aligned)
1. If open, the door will close. If closed, it will open.
2. If closing, the door will reverse.
3. If opening, the door will stop.
4. If the door has been stopped in a partially open

position, it will close.

5. If obstructed while closing, the door will reverse. If the

obstruction interrupts the sensor beam, the opener
lights will blink for fi ve seconds.

6. If obstructed while opening, the door will stop.
7. If fully open, the door will not close when the beam is

broken. The sensor has no effect in the opening cycle.

If the sensor is not installed, or is misaligned, the door
won’t close from a hand-held remote. However, you can
close the door with the Door Control, the Outside Keylock,
or Keyless Entry, if you activate them until down travel
is complete.
If you release them too soon, the door will
reverse.
The opener lights will turn on under the following
conditions: when the opener is initially plugged in; when
power is restored after interruption; when the opener is
activated.
They will turn off automatically after 4-1/2 minutes or
provide constant light when the Light feature on the
Multi-Function Door Control is activated. Bulb size is A19.
Bulb power is 100 watts maximum.
Security

®

light feature: Lights will also turn on when

someone walks through the open garage door. With a
Multi-Function Door Control, this feature may be turned
off as follows: With the opener lights off, press and hold
the light button for 10 seconds, until the light goes on,
then off again. To restore this feature, start with the
opener lights on, then press and hold the light button for
10 seconds until the light goes off, then on again.

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of SEVERE INJURY or DEATH:

WARNING

WARNING

WARNING

WARNING

1. READ AND FOLLOW ALL WARNINGS AND

INSTRUCTIONS.

2. ALWAYS keep remote controls out of reach of

children. NEVER permit children to operate or play
with garage door control push buttons or remote
controls.

3. ONLY activate garage door when it can be seen clearly,

it is properly adjusted, and there are no obstructions to
door travel.

4. ALWAYS keep garage door in sight and away from

people and objects until completely closed. NO ONE
SHOULD CROSS THE PATH OF THE MOVING DOOR.

5. NO ONE SHOULD GO UNDER A STOPPED, PARTIALLY

OPEN DOOR.

6. If possible, use emergency release handle to

disengage trolley ONLY when garage door is CLOSED.
Use caution when using this release with the door
open. Weak or broken springs or unbalanced door
could result in an open door falling rapidly and/or
unexpectedly and increasing the risk of SEVERE
INJURY or DEATH.

7. NEVER use emergency release handle unless garage

doorway is clear of persons and obstructions.

8. NEVER use handle to pull garage door open or closed.

If rope knot becomes untied, you could fall.

9. If one control (force or travel limits) is adjusted, the

other control may also need adjustment.

10. After ANY adjustments are made, the safety reversal

system MUST be tested.

11. Safety reversal system MUST be tested every month.

Garage door MUST reverse on contact with 1-1/2" high
(3.8 cm) object (or a 2x4 laid fl at) on the fl oor. Failure
to adjust the garage door opener properly increases
the risk of SEVERE INJURY or DEATH.

12. ALWAYS KEEP GARAGE DOOR PROPERLY

BALANCED (see page 3). An improperly balanced door
may NOT reverse when required and could result in
SEVERE INJURY or DEATH.

13. ALL repairs to cables, spring assemblies and other

hardware, ALL of which are under EXTREME tension,
MUST be made by a trained door systems technician.

14. ALWAYS disconnect electric power to garage door

opener BEFORE making ANY repairs or removing
covers.

15.

SAVE THESE
INSTRUCTIONS.

Advertising
This manual is related to the following products: