Chamberlain 3130M 1/3 HP - Manual (Page 31)

31
KG
1 3 9 7 5 KG
1 3 9 7 5
LOCK LIGHT
*3-Button Remotes (315 MHz)
If provided with your garage door opener, the
large button is factory
programmed to operate it.
Additional buttons on any
Security
✚
®
3-Button remote
or mini-remote can be
programmed to operate
other Security
✚
®
garage door openers.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote,
fi rst erase all codes:
Press and hold the “learn”
button on motor unit until the
learn indicator light goes out
(approximately 6 seconds). All previous codes are now
erased. Reprogram each remote or keyless entry you
wish to use.
1. Press and hold the button
on the hand-held remote*
that you wish to operate your
garage door.
2. While holding the remote
button, press and hold the
LIGHT button on the
Multi-Function Door Control.
3. Continue holding both buttons
while you press the push bar
on the door control (all three
buttons are held).
4. Release buttons when the
motor unit lights blink. It has
learned the code. If light bulbs
are not installed, two clicks will
be heard.
1. Press and release the “learn”
button on the motor unit.
The learn indicator light will
glow steadily for 30 seconds.
2. Within 30 seconds, press
and hold the button on the
hand-held remote
* that you
wish to operate your garage
door.
3. Release the button when the
motor unit lights blink. It
has learned the code. If light
bulbs are not installed, two
clicks will be heard.
To Add or Reprogram a Hand-held Remote Control
USING THE “LEARN” BUTTON USING THE MULTI-FUNCTION DOOR CONTROL
LOCK
LIGHT
LOCK
LIGHT
PROGRAMMING
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security ✚
® remote controls.
NOTICE: If this Security ✚
® garage door opener is operated with a non-rolling code transmitter, the technical measure
in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.