Local management, 1 overview, Chapter 5 – Cabletron Systems 2E48-27R User Manual
Page 47: Overview -1, Refer to, For information on how to access and use local, Er to, Chapter 5 local management
2E48-27R/2E49-27R User’s Guide
5-1
CHAPTER 5
LOCAL MANAGEMENT
This chapter explains how to set up a management terminal to access
Local Management. It also explains how to use the Local Management
screens and commands.
5.1
OVERVIEW
Local Management for the 2E4X-27R consists of a series of screens that
allow the management of the 2E4X-27R. The screens allow the user to do
the following tasks:
•
Assign IP address and subnet mask.
•
Select a default gateway.
•
Control access by establishing community names.
•
Download a new operation firmware image.
•
Designate which Network Management Workstations receive SNMP
traps from the device.
•
View switch, interface, and RMON statistics.
•
Configure ports.
•
Control the number of receive broadcasts that are switched out to the
other interfaces.
•
Clear NVRAM.
There are three ways to access Local Management:
•
Locally using a VT type terminal connected to the COM port.
•
Remotely using a VT type terminal connected through a modem.
•
In-band through a Telnet connection.