Pro Boat PRB3002 Owners Manual - Manual (Page 10)

10
Push the antenna tube into the antenna mount.
Insert the antenna wire through the antenna mount
and into the antenna tube pushing it through until it
comes out the other end.
Turn the transmitter on then the receiver switch.
Check for correct operation of the radio system.
The rudder control arm should move toward
the front of the boat when right input is given.
Conversely, when left input is given, the control arm
should move toward the back of the boat.
With the propeller free from any objects, give a
small amount of throttle input to ensure the motor
is working. If everything appears to be functioning
correctly, you are ready to run your boat.
Note: If you are transporting your
Mini-V, make sure you disconnect
the battery from the speed
controller and then turn your radio
off until you are ready to run the
boat. Once ready, simply turn the
radio on and plug the battery into
the speed controller, again making
sure that the boat is in neutral.
Left Turn
Section 3: Checking the Radio System
Left Turn