Changing the volume, Voice command, Electronics – Dodge 2010 Dakota User Manual

Page 34

Advertising
background image

Changing The Volume

• Start a dialogue by pressing the Phone button

, then adjust the volume during a

normal call.

• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable level

while the Uconnect™ system is speaking. Please note the volume setting for
Uconnect™ is different than the audio system.

NOTE: To access the tutorial, press the Uconnect™ hard-key. After the BEEP, say
“tutorial”. Press any hard-key or touch the display to cancel the tutorial.

VOICE COMMAND

• The Voice Command system allows you to control your AM, FM radio, satellite radio,

disc player, Uconnect™ Phone and a memo recorder.

• When you press the Voice Command button

located on the radio face plate or

steering wheel, you will hear a beep. The beep is your signal to give a command. If you
do not say a command within a few seconds, the system will present you with a list of
options. If you ever wish to interrupt the system while it lists options, press the Voice
Command button

, listen for the BEEP, and say your command.

• For vehicles equipped with Video Entertainment System (VES)™, refer to the Voice

Command section of the Uconnect™ User's Manual on the DVD for further details.

• For vehicles not equipped with VES™, refer to your vehicle Owner's Manual on the

DVD for Voice Command information.

Changing The Volume

• Start a dialogue by pressing the Voice Command button

, then say a command

(for example, “tutorial”).

• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable level

while the Voice Command system is speaking. The volume setting for Voice Command
is different than the audio system.

WARNING!

Any voice commanded system should be used only in safe driving conditions
following local laws and phone use. All attention should be kept on the roadway
ahead. Failure to do so may result in an accident causing you and others to be
severely injured or killed.

NOTE: To access the tutorial, press the Voice Command button

. After the BEEP,

say “tutorial”. Press any hard-key or touch the display to cancel the tutorial.

ELECTRONICS

32

Advertising