Ram Trucks 2013 Chassis Cab - Diesel Supplement - Manual (Page 81)

remain applied and will not disengage until the engine
speed falls below 1,000 RPM. TCC engagement is desir-
able for certain types of PTO applications (Automatic
Transmission Only).
To operate the PTO via a remote switch, the customer
must make sure the above conditions are met. It is vital
for proper operation that the PTO and remote have been
installed correctly, paying special attention to ensure the
vehicle provided wiring has been connected properly.
This is the responsibility of the installer of the PTO and
switches/remote system. It is the responsibility of the
PTO manufacturer to ensure that their electrical (switches
and remote) system is compatible with the vehicle’s
electrical architecture and software functionality.
NOTE:
Single set speed can be programmed via the
PTO menu on the EVIC screen. Further details are
available at the Ram Truck Bodybuilders website.
www.rambodybuilder.com www.ramtrucks.com.
Mobile Mode
To operate the PTO in this mode the vehicle must meet
the following conditions:
• Mobile mode is activated via the menu on the EVIC
screen.
• (on/off) switch has been activated
• Vehicles with automatic transmission must be in PARK
or DRIVE
• Parking brake must not be applied
• Brake pedal must not be applied
• No vehicle, brake or clutch switch faults present
• Vehicle engine must be running
• PTO must be correctly installed using the vehicle
provided circuits
4
STARTING AND OPERATING 79