Voltage supply to circuit is normal, Specification chart, Glossary – Sears Craftsman 919.153111 User Manual

Page 5: Accessories for use with sears air compressors

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

SPECIFICATION CHART

Model No.

919.153011

919.153111

Horsepower

1

1

Displacement CFM

6.0

6.0

Bore

2%"

2%"

Stroke

1.35“

1.35"

Voltage-Single Phase

120

120

Minimum Branch Circuit Requirement

*15 amps

*15 amps

Tuse Type

“Fusetron"

“Fusetron"

TypeT

Type T

Air Tank Capacity ~ GAL.

8

8 ASME

Approximate Cut-in Pressure

80

80

Approximate Cut-out Pressure

100

100

SCFM (a: 40 psig

4.5

4.5

SCFM (a) 90 psig

3.0

3.0

I CA U T IO N I

These compressors can be operated on a 15 amp circuit if:

1. Voltage supply to circuit is normal.

2. Circuit is not used to supply any other electrical needs (lights, appliances, etc,}

3. Extension cords comply with specifications in owners manual.

4. Circuit is equipped with 15 amp circuit breaker or 15 amp Fusetron Type “T” time delay fuse.

If any of the above conditions cannot be met, or if operation of the compressor repeatedly causes
interruption of the power It may be necessary to operate it from a 20 amp circuit, it Is not necessary to

change the cord set.

‘A circuit breaker is preferred. Use only a fuse or circuit breaker that is the same rating as the branch circuit the air

compressor is operated on. If the air compressor is connected to a circuit protected by fuses, use dual element time
delay fuses (Buss Fusetron Type “T" only).

GLOSSARY

CFIW; Cubic feet per minute.

SCFM: Standard cubic feet per minute; a unit of meas­
ure of air delivery.

PSIG: Pounds per square inch gauge; a unit of meas­

ure of pressure.

ASME: American Society of Mechanical Engineers;
made, tested, inspected and registered to meet the
standards of the ASME.

U.L LISTED: Samples of compressor outfits, taken

from production, were submitted to U.L. and found to
comply with their requirements for design and

performance.

ACCESSORIES FOR USE WITH SEARS AIR COMPRESSORS

The following accessories are available through the current general sales catalog or at full-lint Sears stores.

Cut-In Pressure: While the motor is off, air tank pres­
sure drops as you continue to use your accessory.
When the tank pressure drops to a certain low level the
motor will re-start automatically. The low pressure at

which the motor automatically re-starts is called “cut-in
pressure".

Cut-Out Pressures: When you turn on your air com­
pressor and it begins to run, air pressure in the air tank
begins to build. It builds to a certain high pressure
before the motor automatically shuts off - protecting
your air tank from pressure higher than its capacity.
The high pressure at which the motor shuts off is called
“cut-out pressure".

SPRAY GUNS
BLOW GUNS
AIR CAULKING GUNS

AIR POWERED WASHER GUNS

SANDBLASTERS

AIR BRUSHES
AIR LINE FILTERS
TIRE AIR CHUCKS

PAINT TANKS
AIR TANKS
INFLATER KITS

QUICK CONNECTOR SETS

(various sizes)

VISCOSIMETER
AIR PRESSURE REGULATORS
OIL FOG LUBRICATORS

AIR TOOLS:

Sanders

Drills
Impact wrenches
Hammers

AIR HOSE:

V4",

or

LD.

in various lengths

Advertising
This manual is related to the following products: