Listing approvals, Unpacking and testing the unit, Product dimensions & specifications – Desa VESBMR User Manual

Page 3: Safety information

Advertising
background image

www.desatech.com

117190-01B

3

SAFETY INFORMATION

Continued

12. Always disconnect the unit from the power

supply before performing any cleaning, light

bulb replacement, maintenance, relocating the

heater or when the unit is not in use for long

periods of time.

13. When transporting or storing the unit, keep

it in a dry location, free from dust, excessive

vibration or other factors, which may damage

the unit.

LISTING APPROVALS

This heater has been tested in accordance with the

CSA Standards for fixed and location-dedicated

electric room heaters in the United States. All

components are UL or CSA safety certified.
If you need assistance during installation, please con-

tact your local dealer or the DESA Heating Products

Technical Services Department at 1-866-672-6040.

UNPACKING AND

TESTING THE UNIT

Carefully remove the unit from the box. Prior to

permanently installing the unit, test to make sure

the unit operates properly by plugging the power

supply cord into a conveniently located 120-volt

grounded outlet.

CAUTION: The unit's power

supply cord must be connected

to a properly grounded and pro-

tected 120-volt outlet. Always

use ground fault protection

where required by the electri-

cal code.

WARNING: Do not operate

the unit if it is damaged or has

malfunctioned . If you suspect the

unit is damaged, return the unit

to an authorized service facility

for examination, electrical or me-

chanical adjustment or repair.

Frequency

60 Hz

Heater Power 1500 W
Heater Output 5000 BTUs
Power Supply 120V; 15 Amp

Grounded, Circuit

PRODUCT DIMENSIONS &

SPECIFICATIONS

Figure 1 - Heater Dimensions

Note:

A dedicated power supply circuit is recom-

mended for the unit but not required. Additional

electrical appliances on the same circuit may ex-

ceed the current (amperage) rating for that circuit.

If after the installation of your unit, the circuit

breaker trips or the fuse fails on a repeated basis,

then a dedicated circuit will likely be required. Any

new wiring must be done in compliance with local

and national codes and other applicable regula-

tions in order to reduce the risk of fire, electric

shock or other injuries. Therefore, it is strongly

recommended that you hire a licensed electrician

to complete any such work.

27"

15"

26"

12.5"

25.25"

18"

CGESBMR/VESBMR Remote Controlled

18" Electric Stove

CGESBL/VESBL Remote Controlled

27" Electric Stove

Advertising
This manual is related to the following products: