Lingenfelter L820xxxxxx Lingenfelter C5 C6 Corvette Billet Pedal v1.1 User Manual
Page 3
Page 2.
Read the entire instruction manual before beginning installation. Some stock parts will
be used in reassembly.
When referencing the side of the vehicle, the driver side of the vehicle is considered the
left side and the passenger side of the vehicle is considered the right side of the vehicle.
WARNING: The C5/C6 Corvette MT wide pedal kit (PN: L820040197) is intended for
installation in race vehicles ONLY. The width of the gas pedal is intended to better
facilitate the Heel and Toe driving technique. The close proximity of the gas and brake
pedal covers included in this kit can potentially lead to the gas pedal being inadvertently
pressed while attempting to brake.
1. Line up the supplied gas pedal cover on
the gas pedal and mark the location of the four
screw holes using a silver marker, as shown in
the illustration by the silver dots. Remove the
gas pedal cover and drill a pilot hole at each
marked location using a 1/8” drill bit.
2. Using a Phillips head screwdriver, install
the four (4) self tapping screws into the pedal
cover holes as shown.
NOTE: The accelerator pedal is made of a hard
plastic. Take care not to overtighten the self
tapping screws.
3. The mounting bolts will run through the
holes, as illustrated by the arrows, in the stock
pedals.