Ubiquiti Networks Rockeac - Manual (Page 33)

30
Chapter 5: Services airOS®7 User Guide
Ubiquiti Networks, Inc.
Ping Watchdog Select this option to enable use of Ping
Watchdog.
IP Address To Ping Enter the IP address of the target host
to be monitored by Ping Watchdog.
Ping Interval Enter the time interval (in seconds)
between the ICMP echo requests that are sent by Ping
Watchdog. The default value is 300 seconds.
Startup Delay Enter the initial time delay (in seconds)
until the first ICMP echo request is sent by Ping Watchdog.
The default value is 300 seconds.
The Startup Delay value should be at least 60 seconds
as the network interface and wireless connection
initialization takes a considerable amount of time if the
device is rebooted.
Failure Count to Reboot Enter the number of ICMP
echo response replies. If the specified number of ICMP
echo response packets is not received continuously, Ping
Watchdog will reboot the device. The default value is 3.
Save Support Info Select this option to generate a
support information file in case the Ping Watchdog will
reboot the device.
SNMP Agent
Simple Network Management Protocol (SNMP) is an
application layer protocol that facilitates the exchange
of management information between network
devices. Network administrators use SNMP to monitor
network-attached devices for issues that warrant
attention.
The device contains an SNMP agent, which does the
following:
• Provides an interface for device monitoring using SNMP
• Communicates with SNMP management applications
for network provisioning
• Allows network administrators to monitor network
performance and troubleshoot network problems
For the purpose of equipment identification, configure the
SNMP agent with contact and location information:
SNMP Agent Select this option to enable the SNMP
agent.
SNMP Community Enter the SNMP community string.
It is required to authenticate access to Management
Information Base (MIB) objects and functions as an
embedded password. The device supports a read-only
community string; authorized management stations
have read access to all the objects in the MIB except the
community strings, but do not have write access. The
device supports SNMP v1. The default is public.
Contact Enter the name of the contact who should be
notified in case of emergency.
Location Enter the physical location of the device.
Web Server
This section manages the Web Server parameters.
Web Server HTTP service is enabled by default.
Secure Connection (HTTPS) Secure HTTPS mode is
enabled by default.
Secure Server Port If secure HTTPS mode is enabled,
enter the TCP/IP port of the web server. The default is 443.
Server Port If HTTP mode is enabled, enter the TCP/IP
port of the web server. The default is 80.
Session Timeout Enter the maximum timeout before
the session expires. Once a session expires, you must log
in again using the username and password. The default is
15 minutes.
SSH Server
This section manages the SSH Server parameters.
SSH Server SSH access to the device is enabled by
default.
Server Port Enter the TCP/IP port of the SSH server. The
default is 22.
Password Authentication Enabled by default. You must
authenticate using administrator credentials to grant
SSH access to the device; otherwise, an authorized key is
required.