Dixon SPEEDZTR 44 - Manual (Page 43)

DIXON -43
MAINTENANCE
Pump Belt
Replacing EZT (E-Series Zeroturn Transaxle) belt
Park the mower on a level surface. Engage the
parking brake.
EZT belt removal
NOTE: Be careful not to damage the fan blades on
the EZT´s as this can affect cooling or damage the
EZT´s
Remove the deck belt (see Deck Belt Removal
•
in this section of the manual).
Create slack in the belt by removing the spring
•
on the pump idler arm.
The belt should now be able to be removed
•
from the engine pulley and EZT pulleys.
Belt installation
Wrap the EZT belt around the EZT pulleys •
Route the belt around the inside of the idler •
pulley.
Wrap the belt around the engine pulley.
•
Reattach the spring on the pump idler arm. •
Install clutch on to engine shaft (pulley side •
down) make sure key is installed and align
the clutch anti rotation tab into slot on clutch.
Secure clutch, install wire.
Reinstall the deck belt onto the electric clutch
•
belt (see Deck Belt Removal in this section of
the manual).