Dixon 130211 - DCKC - Manual (Page 7)

7
ASSEMBLY
Assembly Instructions
Tools Required:
Ratchet
Torque Wrench
1/2" Wrench
1/2" Socket
9/16" Wrench
9/16" Socket
(2) 3/4" Wrench
3/4" Socket
Flat Screw Driver
(2) 1” Wrench - open end
RAM/RAM MAG
1. Remove clamshell from crate.
2. Remove two 5/16 x 3/4 carriage bolts from
the lower flange of the rear guard on the
mower.
3. Place (539 114781) Mount Bracket, Lower
in place and secure using four (539 111785)
3/8 x 3/4 carriage bolts, four (539 976979) 3/
8 nyloc hex nut and two (539 107271) 5/16 x
1 carriage bolts. Reuse the two 5/16 nyloc
hex nuts previously removed from the 5/16 x
3/4 carriage bolts. See Figure 1.
4. Lift seat and latch with seat latch.
5. Remove seat springs.
6. Place (539 114786) Plate, Support, Linkage
on frame.
7. Reposition springs and secure with (990209)
5/16 x 1 hex bolts and hex nut previously
removed from seat springs. See Figure 2.
8. Attach two (539 114783) Linkage, Support
to the clamshell assembly as shown in Fig-
ure 2.
9. Secure with two (539 100476) 5/8 hex jam
nut and two (539 115591) 5/8 nyloc hex nut
as shown. Do not tighten nuts.
REAR GUARD
539 114781 MOUNT BRACKET, LOWER
LOWER FLANGE
FIGURE 1
FIGURE 2
539 114786 PLATE,
SUPPORT, LINKAGE