Battery, Maintenance – Dixon Kohler Ram Ultra 27 User Manual

Page 36

Advertising
background image

MAINTENANCE

36

-Dixon

Battery

your mower is equipped with a maintenance free

battery and does not need servicing. However,

periodic charging of the battery with an automotive

type battery charger will extend its life.

Keep battery and terminals clean.

Keep battery bolts tight.

Recharge at 6-10 amperes for 1 hour

To clean battery and terminals
Corrosion and dirt on the battery and terminals can

cause the battery to “leak” power.
1. Open the terminal access doors.
2. Disconnect BLACK battery cable first, then the

RED battery cable and remove the battery from the

machine.

3. Rinse the battery with plain water and dry.
4. Clean terminals and battery cable ends with wire

brush until shiny.

5. Coat terminals with grease or petroleum jelly
6. Reinstall battery.

Replacing battery
1. lift seat and rotate forward.
2. Open terminal access doors
3. Using two ½" wrenches disconnect BlACK battery

cable then RED battery cable.

4. Using a

7

/

16

wrench, remove the bolts on either

side of the terminal guard and lift off guard.

5. Carefully remove the battery from the mower.
6. Install new battery with terminals in the same

position as the old battery.

7. Reinstall battery terminal guard.
8. First connect RED battery cable to positive (+)

battery terminal with hex bolt and hex nut.

9. Connect BlACK grounding cable to negative (-)

battery terminal with remaining hex bolt and hex

nut.

10. Close access doors.
11. lower seat.

Always use protective glasses

when handling the battery.

IMPORTANT INFORMATION
Do not attempt to open or remove caps

or covers. Adding or checking level of

electrolyte is not necessary.
Always use two wrenches for the terminal

screws

WARNING!
Do not short battery terminals by

allowing a wrench or any other

object to contact both terminals at

the same time. Before connecting

battery, remove metal bracelets,

wristwatch bands, rings, etc.
Positive terminal must be

connected first to prevent sparks

from accidental grounding.

CZ-22

1. Terminal guard
2. Access doors
Battery cleaning and installation

1

2

Advertising