Installation – Desa FDCFTP User Manual

Page 9

Advertising
background image

www.desatech.com

111244-01F

9

CAUTION: This fireplace cre-

ates warm air currents. These

currents move heat to wall sur-

faces next to fireplace. Installing

fireplace next to vinyl or cloth

wall coverings or operating

fireplace where impurities (such

as, but not limited to, tobacco

smoke, aromatic candles, clean-

ing fluids, oil or kerosene lamps,

etc.) in the air exist, may discolor

walls or cause odors.

IMPORTANT:

Vent-free fireplaces add moisture to

the air. Although this is beneficial, installing fireplace

in rooms without enough ventilation air may cause

mildew to form from too much moisture. See Air for

Combustion and Ventilation, page 6.
Note:

Your fireplace is designed to be used in zero

clearance installations. Wall or framing material can be

placed directly against any exterior surface on the rear,

sides, or top of your fireplace, except where standoff

spacers are integrally attached. If standoff spacers are

attached to your fireplace, these spacers can be placed

directly against wall or framing materials.
Note:

When installing fireplace directly on carpet-

ing, tile or other combustible material, other than

wood flooring, the fireplace shall be installed on a

metal or wood panel extending the full width and

depth of the fireplace.
Use the dimensions shown for rough openings to

create the easiest installation (see Built-In Fire-

place Installation, page 10).

CHECK GAS TYPE

Use the correct gas type (natural or propane/LP)

for your unit. If your gas supply is not correct, do

not install fireplace. Call dealer where you bought

fireplace for proper type fireplace.

WARNING: This appliance

is equipped for (natural or pro-

pane/LP) gas. Field conversion

is not permitted.

INSTALLATION

NOTICE: This heater is intended

for use as supplemental heat.

Use this heater along with your

primary heating system. Do not

install this heater as your pri-

mary heat source. If you have a

central heating system, you may

run system’s circulating blower

while using heater. This will help

circulate the heat throughout the

house. In the event of a power

outage, you can use this heater

as your primary heat source.

WARNING: A qualified ser-

vice person must install fire-

place. Follow all local codes.

WARNING: Never install the

fireplace

• in a bedroom or bathroom

• in a recreational vehicle

• where curtains, furniture,

clothing, or other flammable

objects are less than 36 inches

from the front, top, or sides of

the fireplace

• as a fireplace insert

• in high traffic areas

• in windy or drafty areas

WARNING: Never install in a

bedroom or bathroom. Any heat-

ing product with a Btu/Hr rating

over 10,000 cannot be used in a

bedroom.

Advertising
This manual is related to the following products: