Getting started, Mount the hardware, Install ethernet/rs485 wiring between modules – Measurement Computing PointScan 100 Series rev.1.0 User Manual

Page 11: Connect power and i/o wiring to the modules, Install communication cabling, Apply power, Configure using io toolkit, Test the system, Configure your computer, Run the (citec) software

Advertising
Getting started, Mount the hardware, Install ethernet/rs485 wiring between modules | Connect power and i/o wiring to the modules, Install communication cabling, Apply power, Configure using io toolkit, Test the system, Configure your computer, Run the (citec) software | Measurement Computing PointScan 100 Series rev.1.0 User Manual | Page 11 / 32 Getting started, Mount the hardware, Install ethernet/rs485 wiring between modules | Connect power and i/o wiring to the modules, Install communication cabling, Apply power, Configure using io toolkit, Test the system, Configure your computer, Run the (citec) software | Measurement Computing PointScan 100 Series rev.1.0 User Manual | Page 11 / 32
Advertising
See also other documents in the category Measurement Computing Hardware: