Eiki DLP Projector EIP-5000 - Manual (Page 29)

27
Connecting to a Computer
Before connecting, ensure that the power cord of the projector from the AC outlet is un-
plugged, and that the devices to be connected are turned off. After making all connections,
turn on the projector and then the other devices. When connecting a computer, ensure that
it is the last device to be turned on after all the connections are made.
Ensure that you have read the owner’s manuals of the devices to be connected before making connections.
Note
• See page 100 “Computer Compatibility Chart” for a list of computer signals compatible with the projector.
Use with computer signals other than those listed may cause some of the functions to not work.
• Connecting computers other than the recommended types may result in damage to the projector, the
computer, or both.
• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest
Macintosh Dealer.
• Depending on the computer you are using, an image may not be projected unless the computer’s
external output port is switched on. Refer to the specific instructions in your computer owner’s manual
to enable your computer’s external output port.
Connecting with the RGB Cable
RGB cable
Supplied
accessory
Note
• With this connection, the projector is not compatible to the sync on green signals.
• When using the ø3.5 mm mono audio cable, the volume level will be half of when using the ø3.5 mm stereo audio cable.
To audio output terminal
To RGB output
terminal
To INPUT 1 terminal
ø3.5 mm stereo or mono audio cable
(commercially available)
RGB cable
To AUDIO input (1) terminal
Computer Side view