Extron Electronics RGB 201 - Manual (Page 5)

RGB 201 Rxi Universal Interface • Quick Start Guide
Quick Start Guide — RGB 201 Rxi
Step 1
Turn the equipment off and disconnect the equipment from the
power source.
Step 2
For positive or negative output sync (rather than sync following the
input), RsGsBs video, or to clamp sync timing to back porch)
, open
the interface’s case and configure the jumpers and/or DIP switches.
See Internal Configuration, beginning on page 2-3, for details.
Step 3
Rack, under-desk, or through-desk mount the interface as desired .
Rack mounting — Use the optional 1U Rack Shelf, part #60-190-01,
for rack mounting.
Under desk mounting
— Use the optional Under-Desk Mount Kit,
part #70-077-01, to mount the DA under furniture.
Thru-desk mounting
— Use the optional Thru-Desk Mount Kit, part
#70-077-02, to mount the DA through furniture.
Step 4
Video input — Connect the RGBHV, RGBS, RGsB or RsGsBs video
input to the 15-pin HD Input connector.
Step 5
Audio input — Connect an unbalanced stereo audio source (such
as a computer or a CD player) to the 3.5 mm mini stereo Audio
connector for unbalanced audio input. See the figure below to wire
the audio plug.
Tip (Left) Sleeve (Gnd)
Tip (Left)
Ring (Right)
Sleeve (Gnd)
Step 6
Buffered monitor output — If desired, connect a local monitor or
other device to this 15-pin HD female connector.
Step 7
Video output — Connect an RGBHV, RGBS, RGsB or (if configured
in step 2, above) RsGsBs video display or other device as shown on
the next page.