Epson 1200S - Manual (Page 88)

Troubleshooting Page 88
Problems Using the Start Button
You see the message “No Push button scanner detected.”
When you press the Start button, nothing happens.
Problem Solution
Scanner monitoring
doesn’t detect the
scanner. The EPSON Scanner Monitor periodically checks on the status of your
scanner to make sure it’s ready. Sometimes the scanner check occurs
when your system is processing other information and the scanner is not
detected during that particular check. (You may see this message
anytime, not just when you press the Start button.)
If you see this message, make sure your scanner cable is securely
connected. Then open and close the scanner monitoring utility to
manually check for the scanner. See
Enabling Scanner Monitoring for
instructions. If you still see the message, turn off your scanner, then turn
it on again and restart your system.
Problem Solution
Scanner monitoring is
not enabled. Scanner monitoring must be enabled for the Start button to work. See
Enabling Scanner Monitoring for instructions.